The online website extender.linksys.com is used to configure Linksys Extender Setup. When properly configured, the wifi range extender setup enables you to start with advanced settings. Nowadays people use high-frequency, powerful WiFi routers to meet their internet needs.
However, the signal may be poor or absent in some locations. Dead network locations or areas are the names for these areas. picking out a Linksys WiFi extender rather than a new router. The installation cost of the Linksys extender is only a third that of the router.
Linksys WiFi extender boosts the signal so you can access the internet at home or at work. Therefore the topic of how to set up a Linksys WiFi extender now arises. Before you can do it, a few things need to be prepared.
Linksys extender Setup via wps button
Wi-Fi Protected Setup is known as WPS. This button only works on one device at once. Your Linksys extender’s front or rear panel contains the WPS button. WPS is not a feature on many routers.
- The WPS button’s primary role is to act as the network security standard that speeds up connections to wireless devices and routers. Do the actions listed below:
- Check the Linksys WiFi range extender router’s connection.
- The Linksys WiFi range extender should be connected to an electrical switch.
- Wait a brief while after the power LED on your Linksys WiFi expansion turns solid.
- Therefore, depress the WPS button on the back or side of the device.
- Make sure your home WiFi router and wireless extender are in the same location while setting up a Linksys WiFi extender without going to extender.linksys.com.
Note: If you need any assistance regarding your linksys wifi extender so contact our technician or visit the official website that is extender.linksys.com.
How to access the extender.linksys.com page for Linksys wifi Extender Setup
The steps listed below should be followed to set up a Linksys wifi extender using the wireless protected setup (WPS) method:
- Make sure your Linksys WiFi extender is properly configured at home (extender.linksys.com).
- Connect your Linksys extender to an electrical power switch at this point.
- Watch for your Linksys WiFi extender’s power Indicator to turn solid amber.
- On the device’s back or side panel, press the WPS button.
- Critical Reminder: Make sure your home Wi-Fi router and wireless extender are in the same room while configuring your Linksys WiFi Extender without going to Linksys.com.
How to Install Linksys WiFi Extender via Extender.linksys.com
Linksys wireless With the online pages Extender.Linksys.com or Extender.Linksys.Setup, Extender Setup can be completed. However, one must be aware that Extender.Linksys.com is where these pages are located and Extender.Linksys.Setup cannot be viewed online.
As a result, you can also setup LINKSYS WIFI Extender Setup by visiting Extender.Linksys.com.
The steps to be taken are:
- First, connect the Linksys extender to an electrical outlet.
- Enter http://extender.linksys.com or 192.168.1.1 in the address bar to begin the setup process.
- Change your browser if the Linksys extender setup page won’t appear.
- Because it will question how you would like to install Linksys Extender on the setup page.
- Depending on your needs, select the Linksys wifi access point or range extender option.
- Choose the WiFi network you want to grow.
- As a result, just follow the online instructions to finish the setup.
- Finally, the After Setup Successful Connection page will shut down on its own.
- To receive speedy internet with the highest power possible, plug the extender into the spot finder.